A G-code pause, G04 command, or dwell command is a command to pause your 3D printer for a certain amount of time, normally measured in seconds or milliseconds. This command is available on any...
3D Printing For Enthusiasts & Experts.
Recent Posts
If you’re consistently dealing with difficult-to-remove 3D print supports, chances are, the issue is your printer settings. Supports will always take some time to remove. However, they should...
If your 3D printer is creating models with a ripple or wave effect on the outside, you have an issue known as ringing or ghosting. When that happens, it’s always caused by one thing:...
If your prints are sticking to the FEP film, getting them off can be nerve-wracking. Often, you can simply pop them off by sliding a nail under one edge and lifting from the corner. But, every...
If you’re using a resin 3D printer, you’ll eventually have to clean the vat and the FEP film. Failing to clean the vat can cause clouding and printing problems, sometimes in as little as two...
If you’re considering printing or already printing with vat photopolymerization 3D printing technologies known as “resin printers”, you’ve probably heard that the UV resin used in the...